Industrial Component
Hardware

Show all

[How to Use]
—1. Install the adjustment jig

①Fit the adjustment jig firmly into the body.

*Right-handed and left-handed available.

*Be sure to adjust the counter plate position after adjusting the installation position of the hinges.

Show all

—2. Horizontally adjust the counter plate

①Loosen the horizontal adjustment screws.

②While holding the adjustment jig by hand, slowly close the door and align the counter plate shaft with the groove.

③Tighten the horizontal adjustment screws.

Show all

—3. Vertically adjust the counter plate

①Loosen the fixing nut.

②While holding the adjustment jig by hand, slowly close the door and align the top of counter plate shaft with the bottom of jig.

③Tighten the fixing nut or the counter plate shaft firmly.

Show all

—4. Check

①When removing the jig and closing the door slowly to the end, “click” sounds once.

*If the door does not close to the end or “click” sounds twice, perform depth adjustment.

②When opening the door, “click” sounds once, and the arm is pulled out.

*If the arm can not be pulled out, perform depth adjustment.

③Check if the clearance between the arm and the counter plate shaft is appropriate.

Show all

*Depth adjustment of the counter plate (adjustment jig LDD-V-JIG can not be used for depth adjustment).

①Loosen the depth adjustment screws.

②Align the centre of the counter plate shaft with that of the door thickness.

③Tighten the depth adjustment screws.